gl2t1a 0 Posted June 10, 2009 Arrrgggghhhh!!!! Having flown my Camel through both phases of OFF, I now am proficient but have no control over what is frequently killing my pilot or landing him in enemy territory. This happens when I exit warp into a cloud, get thrown into an uncontrollable spin or experience a structural failure. Bailing out just lands me behind enemy lines. Other times I will come out of warp at 400 knots! What's really aggravating is trying to warp during an escort mission only to have the aircraft zoom out off the depicted line of flight sometimes 600 miles until the systems craps out. Not using warp is probably the answer but I don't have hours to devote to a mission. Anyone find any solutions here? Ranger Mike Share this post Link to post Share on other sites
UK_Widowmaker 571 Posted June 10, 2009 http://forum.combatace.com/index.php?showtopic=42253 Share this post Link to post Share on other sites
jayo 0 Posted June 10, 2009 (edited) Is this international warp week or something? Edited June 10, 2009 by jayo Share this post Link to post Share on other sites
UK_Widowmaker 571 Posted June 10, 2009 Is this international warp week or something? My Wife say's I'm Warped'....But I don't believe her! Share this post Link to post Share on other sites
gl2t1a 0 Posted June 10, 2009 http://forum.combatace.com/index.php?showtopic=42253 Thanks for the tips. However, the only cheat I'm using is auto-mixture. What can I do about exiting warp into a turbulent cloud mass? What's happening with the escort missions when warp suddenly takes me off course and out into the North Sea? Gotta be a way to fix this. Ranger Mike Share this post Link to post Share on other sites
jayo 0 Posted June 10, 2009 (edited) Are you going off course after the aircraft you're escorting have landed? As soon as they have you need to come out of warp and either point yourself in the right direction,or select the next waypoint,and then hit warp again....should be ok. Dont warp on cloudy days,instead use the time advance (Ctrl+R?). Edited June 10, 2009 by jayo Share this post Link to post Share on other sites
gaw 5 Posted June 10, 2009 It's auto-trim. You have to disable auto trim before you go into warp and then re-enable it when you come out. If you use auto trim, which I do, it causes an uncontrollable downward pitch exiting warp unless it's been turned off before you enter. If this ain't the problem, forgive me. Someone was kind enough to solve this for me a while back! Share this post Link to post Share on other sites
