Jump to content
Sign in to follow this  
Shrapnel

Need help with a few issues

Recommended Posts

Hi,

 

Whenever I get dropped out of warp mode my engine is always stalled out and it takes several minutes sometimes to coax it back to full throttle. This has very bad consequences when there are enemy aircraft about. Anyone know how to fix this?

 

I started a new campaign as a RAF pilot in the 29th and started my first mission. I proceeded to the airfield I was to protect and got into a scrap w/ Fokker EIII's and I managed to shoot one down. Then I was shredded by his squad mates and started plummeting to the Earth not in control of my shot up aircraft. My plane was spinning down but before I hit the Earth I'm switched to the de-briefing screen health and alive (though my plane is a total loss).

 

Is there a fix for this?

 

Thanks.

Share this post


Link to post
Share on other sites

Hi,

 

Whenever I get dropped out of warp mode my engine is always stalled out and it takes several minutes sometimes to coax it back to full throttle. This has very bad consequences when there are enemy aircraft about. Anyone know how to fix this?

 

I started a new campaign as a RAF pilot in the 29th and started my first mission. I proceeded to the airfield I was to protect and got into a scrap w/ Fokker EIII's and I managed to shoot one down. Then I was shredded by his squad mates and started plummeting to the Earth not in control of my shot up aircraft. My plane was spinning down but before I hit the Earth I'm switched to the de-briefing screen health and alive (though my plane is a total loss).

 

Is there a fix for this?

 

Thanks.

 

1) Make sure you have adjusted the engine air fuel mixture for altitude.

 

2) Check your settings in workshops for survivability etc.

 

 

HTH

 

WM

Share this post


Link to post
Share on other sites
1) Make sure you have adjusted the engine air fuel mixture for altitude.

 

2) Check your settings in workshops for survivability etc.

 

 

HTH

 

WM

 

1) Ah thank you - I had auto mixture off.

 

2) My setting is "Hard - Dead is dead". But I don't think that is relevant since I did not get to die. Before I was near hitting the ground I was teleported to the de-brief screen.

Share this post


Link to post
Share on other sites
1) Ah thank you - I had auto mixture off.

 

2) My setting is "Hard - Dead is dead". But I don't think that is relevant since I did not get to die. Before I was near hitting the ground I was teleported to the de-brief screen.

 

Yes the sim exits if the craft is no longer flyable - we are looking into this in a little more detail/flexibility for the next phase.

 

But to make sure your pilot does die and that your install is O.K - take-off and then dive at high speed into the ground - your pilot should die.

 

WM

Share this post


Link to post
Share on other sites
take-off and then dive at high speed into the ground - your pilot should die.

 

WM

 

And deserves too....Bally Idiot! ..Months of training wasted! :biggrin:

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×

Important Information

By using this site, you agree to our Terms of Use, Privacy Policy, and We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue..