Cleaver
-
Posts
105 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Downloads
Store
Everything posted by Cleaver
-
From the album: AGM-12
-
From the album: AGM-12
Spring-loaded latch for wing retention to missile body. -
From the album: AGM-12
Coax connector at forward end of wing. -
From the album: AGM-12
View looking forward into the nosecone with camera flash turned on... -
From the album: AGM-12
View looking forward into the nosecone. -
From the album: AGM-12
Alignment notch that mates to similar one on aft portion of TDD housing. -
From the album: AGM-12
Nose, clamp and hardware from TDD. -
From the album: AGM-12
-
From the album: AGM-12
-
From the album: AGM-12
-
From the album: AGM-12
View looking aft with TDD upper structure removed. Unopened plastic bag contains an electrical adapter that connects the TDD to the guidance system wiring. -
From the album: AGM-12
Terminal block. -
From the album: AGM-12
-
From the album: AGM-12
-
From the album: AGM-12
Close up of lugs that mate the guidance section to the warhead. A band clamp would encircle the lugs and would lay flush in the lug grooves to provide retention. -
From the album: AGM-12
-
From the album: AGM-12
View looking forward from just past the intersection of fin shaft intersection. -
From the album: AGM-12
View looking forward with Crystal Access panel on left. The previous owner glued aluminum bars between opposing fin shafts to retain them and allow simultaneous rotation. Guidance system is removed, including the fin actuators. Plastic plugs were used for the bearing surfaces of the fin shafts, and one is plugging the hole for the initiator squib port. -
From the album: AGM-12
-
From the album: AGM-12
The 8 dots around the periphery of the lower section of the TDD are just sealer covering the attach screws. -
From the album: AGM-12
-
From the album: AGM-12
-
From the album: AGM-12
-
From the album: AGM-12
-
From the album: AGM-12
