one zero 0 Posted April 20, 2010 Folks, I have loaded Phase 3, HITR, 1.47 patch and selected Windows XP SP2 in the compatability mode. Everything works great with one small exception, Everything is full screen until I select "Go To Field" My screen is then reduced to approximately to 10x10. I can still fly with configuration but do not get the full picture so it is really unusable in this state. Anyone got any suggestions? I have done everything that know how to do with negative results! One Zero sends. Share this post Link to post Share on other sites
Von Paulus 8 Posted April 20, 2010 Have you run cfs3config.exe? Share this post Link to post Share on other sites
Olham 164 Posted April 21, 2010 (edited) Click on "Workshop" from the start screen; click on "Graphic settings" there; click on "file"; click on "Change display options"; choose your resolution. (This may sometime slip back, so at next start, it could be set wrong again. Best to check it after every new start of the sim). Also make sure after that, that the FOV (field of view) relationship is right. Here, the length to width relationship of your screen can be translated into FOV numbers. The larger the numbers (I think?), the wider is your FOV, and the smaller do aircraft appear. Set it to your likes. Edited April 21, 2010 by Olham Share this post Link to post Share on other sites
