Decal fault...

[+SidDogg 130]

To anyone who might know...

 

check it out.

 

Of course, I'm modding a new skin for the Super Hornet, and I'm getting this across the center fuselage:

 

 

I have two Level 2 Decals on either side of the Seat Spine. But the "Break" in the middle still remains.

 

So far, I have swapped decals, models, and INI dances.

 

...Any Ideas?

 

 

 

 

SidDogg

[+SidDogg 130]

Alright folks.

 

I am thankful to every one who looked into this.

 

Shortly after I began this thread, I went back and did further troubleshooting...

 

Got it fixed.

 

 

It seems there was everything wrong with the entire Decals.INI itself.

 

Took the one from one of my old SF1 skins, now it works like a champ.

 

So, perhaps if you run into an issue like this...

 

You might need to swap out the whole Decal.INI

 

That is all!!!

 

 

 

 

SidDogg

[+Gocad 26]

I'd be surprised if the issue is the file itself, I would rather assume that its content is to blame...

[+SidDogg 130]

Hence the swapout of the entire file...

 

I looked and looked and looke throught it before...

 

All entries were proper.

 

That's what confused me.

 

 

 

 

SidDogg

[Wrench 9,847]

it's amazing what a single typo will do....was going nuts trying to figure out WHY the serial number decals weren't showing on the BirdDog....

 

the difference was between the 0 (zero) and O (oh). Eyes must be going....

[+SidDogg 130]

Hmmm.....I see

 

I wiil see to that next time!

 

 

 

 

 

SidDogg