Anyone Using The X-45 With Lomac?

[zagnut 0]

Hi all,

 

Is anyone using the X-45 with LOMAC, b/c I've reset the axis controllers, and everytime I load a new flight it doesn't work (Of course I hit alt-q to take over flying after startup -s-) Anyone have any ideas?

[BirdDogg 0]

I use the X45, I've not had the problem your talking about though.

 

What you can try is: Go to your LOMAC dir on your harddrive select your Input directory(for controllers) I believe it's Lomac\bazar\Input or Control, and right-click the diretory folder, and uncheck the read only box. make sure to apply this change to all files.

 

This should allow you to save your input changes.

 

Hope this helps

 

BirdDogg.

[bflagg 0]

Go to your Lomac install directory, right click , properties, and

uncheck "read only".

"apply to all folders and subfolders".

 

If that doesn't work, go to the contollers directory and remove

their predefined X45 config file.

 

Hey on my box, occasionally the X45 becomes unresponsive totally

and I have to reboot to get it back.

Power savings is turned off on the USB hubs so I'm out of Ideas

(there is a USB patch - post XPsp1 - on MS site)

[grmcle 0]

Recently I read that the X-45 must be programmed in the stick profiler software only to be able to function properly.

[tc223 0]

grmcle,

 

Everything you need is right here.. user: PRECOG, did some excellent work on this subject.

 

For more details. See Precogs EXCELLENT Thread on this here:

http://forums.ubi.com/messages/message_vie...mac_gd&id=zsehb

 

 

( i like precog, can you tell? :D )

Edited December 18, 2003 by tc223

[zagnut 0]

<S!> All,

 

I just got done adjusting those properties in the install dir. Thanks alot! I think alot to do with it was just breaking the bloody thing in... The stick's a little stiff if ya don't use it I guess!

[tc223 0]

Zag,

I loosed up the throttle a bit via the adj. screw on the bottom of the base. Helped a bit.