not holding grahpic setting

[thewoo1 0]

Guys I set my resolution st my samples to 4below that and exit out not using the x but going back to the window my sample return back to none when I end mission and check it ty thewoo1

[Check Six 2]

Guys I set my resolution st my samples to 4below that and exit out not using the x but going back to the window my sample return back to none when I end mission and check it ty thewoo1

 

When you set your resolution and your sampling, DO NOT exit using the red X at the top right of that box. Pull down the drop down menu under "File" and there is an exit command there. Use that, or it won't save your choices. You say you're not using it, but I suspect there's something amiss.

 

If you are saying that after exiting, the resolution is still saved, but the sampling isn't, and that it has reset, don't worry. I believe that it does save it, it just doesn't display that it does. You're not doing anything wrong.

Edited July 29, 2009 by Check Six

[thewoo1 0]

When you set your resolution and your sampling, DO NOT exit using the red X at the top right of that box. Pull down the drop down menu under "File" and there is an exit command there. Use that, or it won't save your choices. You say you're not using it, but I suspect there's something amiss.

 

If you are saying that after exiting, the resolution is still saved, but the sampling isn't, and that it has reset, don't worry. I believe that it does save it, it just doesn't display that it does. You're not doing anything wrong.

 

 

thanks I hopr your right I see rom other posts ohter guys have the issue seems nvidia card are some of them

[Check Six 2]

thewoo1,

 

The "anti-aliasing settings" seem to reset to none after you set it to 2x or 8x etc, but I'm pretty sure it retains them...just when you re-enter to tweak some more, it has reset to default. I think it was Homeboy that said it didn't, and he's the guy who'd know.

[+Polovski 460]

Ignore what it says in that box. File, Exit works. If you go back, the settings are not displayed correctly. Then the only safe way is to set them again, File, Exit. (Not using the X in the box as said above)

 

I believe I described that in the FAQ near the top too.