lederhosen Posted July 21, 2011 Posted July 21, 2011 Salute when i watch the ground from external views the ground looks great and I can see foe miles on end When I switch to cockpit or gunner the ground within a smaller radius looks the same and then the rest changes and far off its just green. From some of the vids I have seen this dont seem to happen to other pilots, wonder why? Led Quote
Panama Red Posted July 21, 2011 Posted July 21, 2011 What is your "Scenery" and "Terrain" numbers ??? Most PC's handle a "3" each, but if you have a good PC, you can up it to "4" for each. Quote
Panama Red Posted July 21, 2011 Posted July 21, 2011 I have a "4" for each with my new video card, and my scenery & terrain with trees and buildings goes clear out to the horizon. I suspect that the videos that you see have either both "3"s or "4"s for the scenery and terrain. Try upping your numbers and see for yourself what it looks like (even if you can not fly that way all the time). Quote
lederhosen Posted July 22, 2011 Author Posted July 22, 2011 I went 4/4 no probs for PC, but the view remains the same. Quote
Panama Red Posted July 22, 2011 Posted July 22, 2011 What is you ground object density setting in the Workshop setting screen ??? Quote
lederhosen Posted July 23, 2011 Author Posted July 23, 2011 Salute Med. setting anyway, bad example but this is what I mean this is what I normaly see out side. Bad example though. Other day I flew near Verdun, and you could watch from a far all the artillery explosions going off over the mud...cool and this is what I get when in cockpit. As mentioned above over Verdun, I could make out the lines (somewhat) but the arty hits were not to be seen It seems that everything quite near is good, but then it sort of gets distorted like being under water. Just wandering if this is normal. But looking at other peoples vids they have great view from cockpit. Led Quote
lederhosen Posted July 23, 2011 Author Posted July 23, 2011 Salute SOLVED!!!! had to go into workshop, then reset my graphic mode to standard. Changed the standard settings a bit but this time I didn't change any of the "parameter editor for texture" settings. Now it looks correct. danke and sry for the mistake Led Quote
Panama Red Posted July 23, 2011 Posted July 23, 2011 Glad you figured it out, I was running out of ideas on what could be your problem. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.