manlyman564 0 Posted December 28, 2011 hi question what is unicode in skunks works it asys to get the b-2 to work in sf2 u need to chane the ini to unicode how do i do that and what is unicode thank u for your time Share this post Link to post Share on other sites
+RAVEN 414 Posted December 28, 2011 (edited) Ok If you open any of the aircraft .ini's, _ Data, _cockpit, _ textureset, ect with Notepad Then select Save As, at the bottom you will see where to save as ANSI or UNICODE, In the Encoding Section. Just seclect the one you need. Raven Edited December 28, 2011 by RAVEN Share this post Link to post Share on other sites
Wrench 9,846 Posted December 28, 2011 unnecessary to make changes; SF2 reads both ANSI and Unicode -- all my terrain, aircraft etc inis are in ANSI and nobody's complained of a problem. Share this post Link to post Share on other sites
Padre 13 Posted December 28, 2011 This is good to know, I spent two hours the other day looking for a "converter". Share this post Link to post Share on other sites
