ace888

Love the Phantom...

Test Flight...

Had to give up the aft sparrow, permanent loadouts base on type of mission selected... It has been a while doing loads, had to think about it...

Finally figure out a method to load the rear Sparrows with the LP and EP pods.

Testing .LODs on Volker's versions of his "Simsek"

112 Filo "Seytan" Simsek Projesi... Need to redo the serial number and minor tweaks then it is done.

...

112 Filo "Simsek"

...

Test Flight. Made from scratch... trying to replicate the actual aircraft.

My friends... I know you guys have your projects set... Just posting for viewing. Keep up the excellent work!!!

Almost there Dels... Exceptional job as always

Super super.... WBS!

Day Test and Night Run...

Turk Hava Kuvvetleri RF-4ETM Isik Projesi Isik (Light) 113 Filo Safak (Dawn) 173 Filo WIP...

I can't even find the photos you have found... less alone new ones The photos might not help much but I think you already have the AN/ALE-41 made... The J/ALQ-6 side view might just help a ta-bit?

Did a revised on Tank 600 and a little data.ini on the cockpit...

Can't wait to see "Volker's" excellent Phantom Trilogy! Having play SF2 in a while... scooting along with some old JASDF skin.

Thank you Erik! It is never enough thanks for all involve to keep this community going.

A Huge Thumbs UP Volker!!! Require screenshots... New Helmets, JHMCS type (F-15J) and a home develope type compare to a current one (F-2).

Nice work Coupi... Good work on removing the forward screen frame.

Thanks for the excellent information. Will come handy...

Is it me or the nose needle is not model correctly? It is pointed down too far? I have looked through many screen post and all of them are pointed way to far down. Going to stick to the excellent Spillone's F-104 pack

Volker, I assume you have test the following? Not an expert just trying to see if I understood your situation? Example: [HUD] HUDMaterial=HUDMaterial HUDColor=0.18,1.0,0.48,0.80 BoresightOffset=0.0,0.0 ViewportTopLeft=-0.115,-0.07 ViewportBottomRight=0.115,0.227 RocketBoresightAngle=-3.0 Adjusting the 'two' different values... would that work? I think you should be able to adjust the size of the entire content on the HUD (width and height)? You have probably already try that, right? Love your work, sorry if I was not helpful...