Vicshere 0 Posted September 5, 2009 (edited) OK, Fresh Install of CFS3 Patched to 3.1 install OFF Install OFF Superpatch Install OFF mini patch Run Desktop Icon CDBurnerXP Pro 3.msi comes up, looking for Use Source 1. What gives? It is LEGIT pressed disk. It is dated 2002. I had to upgrade it via the patch to 3.1 which I did. It is an original MS Games Studios disk. CFS3 loads and plays fine, but OFF gives me this weird message of wanting CDBurnerXP Pro 3.msi in source 1. So, out of desperation, I placed disk 1 in the drive (if I recall correctly, disk 2 is used to play CFS3), but with the same results. Edited September 5, 2009 by Vicshere Share this post Link to post Share on other sites
Macklroy 2 Posted September 5, 2009 Posted by RafLou in your thread in general forums. Hope this helps. --- Vicshere, sounds like you have a problem with your CDBurnerXP program. Here is the link to a help thread on exactly your issue: http://forum.cdburne...opic.php?t=2300 Hope it works for you Sir. Cheers! Lou --- Share this post Link to post Share on other sites
Fortiesboy 3 Posted September 5, 2009 (edited) OK, Fresh Install of CFS3 Patched to 3.1 You did right to here. What you may have done ( you don't say), and what you HAVE to do at this point, is fly a mission for a few seconds- any mission for just a short while. ( Running this CFS3 mission will put some necessary files in the registry which OFF uses when you install OFF ) Then you exit the mission and install OFF It is LEGIT pressed disk. It is dated 2002. I had to upgrade it via the patch to 3.1 which I did. It is an original MS Games Studios disk. As this is an original 2 disc CFS3, not a Later DVD version, it is my understanding that you will always need to have the disc in the drive to play CFS3 and OFF! (That's why your comment about "in desparation putting in the disc etc " confuses me ?? ) Can't help re the burner thing, I'm afraid Edited September 5, 2009 by Fortiesboy Share this post Link to post Share on other sites
Vicshere 0 Posted September 5, 2009 Well, in the 2 cd set, you use cd1 to load CFS3, but since it was asking for source 1, I thought try disk one. At any rate, after a night of tinkering with the grease monkeys in the hanger, I got this thing to run LOL. I removed the CDBurner program (its a freebie anyway and there is a new version), read a little on multiple forums for clues, took care of CFS3 stutter,and finally got to leave mother earth behind Share this post Link to post Share on other sites
