Mixture Control for Caudron G4

[mandrews_2 11]

So I was just flying a mission in a Caudron G4 and found I couldn't climb or catch up with my flight leader.  Looking at the RPM gauges, by adjusting the mixture I could get the left engine to ~1200rpm; but my right engine was only getting 900rpm.  Both engines were showing 100% health (so no engine damage).  On a lark, I turned on auto-pilot and immediately the right engine RPMS started climbing to 1200 like the left.  Is there something I'm missing (separate mixture controls) or is there something going on with the G4 engine management?

Edited April 30, 2021 by mandrews_2
clarity

[mandrews_2 11]

OK A bit more information from a couple of QCs.  In the G4 cockpit, I only see one of the two mixture controls move when I adjust the mixture, and I can kill the left engine (never the right) by cutting back the mixture too much.  QC flight in a Gotha shows similar behavior (al least with the mixture cut out).

[Burning Beard 14]

Just guessing I would think you have to adjust the mixture for each engine individually.  If you look in engine controls in the key mapping in Workshops, there are individual controls for up to four engines.  

[mandrews_2 11]

2 hours ago, Burning Beard said:

Just guessing I would think you have to adjust the mixture for each engine individually.  If you look in engine controls in the key mapping in Workshops, there are individual controls for up to four engines.  

Good guess @Burning Beard.  That's it, I need to select the second engine.  Works great with the keyboard, now to figure out if I can control both engine mixtures together using my HOTAS dial.

[+Polovski 460]

Indeed the default will be to apply mixture changes or whatever, to the first engine. Select the second engine, then you can control that.

Shift+1 - engine 1 select.
Shift+2 - engine 2 select. etc

then you can adjust.

Go to the WOFF keys setup and top right, filter, Engine controls and you can see these and others.

 

 

 

Edited May 1, 2021 by Polovski

[Bletchley 8]

There is also a key to select all engines, if you want to control both engines as one...

B.

[TROOPER117 146]

Thanks for the heads up... some useful little reminders here  

[+Polovski 460]

Yes good point B.

 

[mandrews_2 11]

Perhaps this statement belongs in the "Wish List" thread; but I'll make it here.

I wish there was a "Mixture Control All Engines" or "Mixture Control All Selected Engines" command available in the "Bind to Axis" list of the Key/Controller Mapping utility.  The current list is tied to Engine1 - Engine4 individually.  This is what triggered my initial confusion.