Fracture's A-4 two-seater

[+amariani 5,137]

Any cure for the non-working left aileron?

[+Soulfreak 6,546]

1 hour ago, amariani said:

Any cure for the non-working left aileron?

 

 

Maybe not animated in 3d model?

[Wrench 10,161]

Could you be more specific? We have 3 different models of TA-4s. F, H, J. So, which one or is it all??

Did you check the node names are correct? And "angles of operation"? I haven't touched them since 2017, so ..?????

[+Cliff7600 1,210]

The ailerons are working on the TA-4J

 

The control surfaces are never animated in the 3D model, it's ini only moves.
Issues from the 3D model are pivot points or rotation axes (and even rotation axes can be changed in the data.ini file).

----------------------------------------------------------------------------------------------------------------------

It's the OA-4M and it's a line missing in the data.ini file : "InputName=ROLL_CONTROL"

[LeftAileron]
SystemType=CONTROL_SURFACE
InputName=ROLL_CONTROL
MaxDeflection=20.0
MinDeflection=-20.0

Edited yesterday at 10:09 AM by Cliff7600

[Wrench 10,161]

Wonder if that was my fault, when I rebuilt the data ini in 2012?

[+Cliff7600 1,210]

@Wrench In this case you can update it, when it's someone else's release you can't.

Edited yesterday at 07:55 PM by Cliff7600

[+amariani 5,137]

11 hours ago, Cliff7600 said:

The ailerons are working on the TA-4J

 

The control surfaces are never animated in the 3D model, it's ini only moves.
Issues from the 3D model are pivot points or rotation axes (and even rotation axes can be changed in the data.ini file).

----------------------------------------------------------------------------------------------------------------------

It's the OA-4M and it's a line missing in the data.ini file : "InputName=ROLL_CONTROL"

[LeftAileron]
SystemType=CONTROL_SURFACE
InputName=ROLL_CONTROL
MaxDeflection=20.0
MinDeflection=-20.0

That was it, thanks!