Jump to content

Recommended Posts

Posted

'Been at it for twenty minutes, and every time, it wants to slide off on one wing [right or left] just before it gets to the top of the arc. This may be an exercise in futility since the E.III can't catch anything anyway, but someday I may get to pounce on a cripple limping home.

Posted

Make sure you have picked up as much speed as possible before trying the loop or Immelman. Your climb angle is probably also important. Has anyone else been able to do these maneuvers in an EIII? If not, maybe the devs would consider moving the center of gravity on the EIII slightly aft to perhaps improve its climbing/looping ability.

Posted
My Word. . but, you've a been terror ever since you discovered the presence of a cockpit :biggrin:

 

 

Nothing and nobody is more passionate than a convert!

 

I had my computer techs put together a 3D-modeling/animation system for me about four months ago. I don't have the spec. sheet in hand, but it's either the Core 2 Quad, or the Core 2 Duo [i suspect the latter] that I'm running with 64-bit Vista and 8 Gb RAM. So I think the computer will put the E.III over the top if the E.III is up to it.

 

My version of an Immelman? Basically the Split-S but going vertical.

Posted

Yep, the Immelmann can be done with it. Nose dive some 30°, until you don't gain much speed

anymore, and then pull up hard., to finish the half loop as quick as possible. Give counter rudder

against the side, she wants to drift sidewards to; but careful! That's it; the roll-round is easy.

Posted
Yep, the Immelmann can be done with it.

 

Well, it did it. Up and over. I tried repeatedly to do it from the cockpit, but it kept sliding off on one wing. I changed to my old fave: the tail-chase view. The first thing I found out was that my Logitech stick doesn't move the rudder except for the most miniscule amount. [as opposed to the DH-2, and others, where it moves a great deal.] Horizontal elevators move well. While in tail-chase I tried again. This time it went. I suspect it worked because I had a better view of the horizon and was holding the stick steady.

Posted

The link I posted explains at the top a modern Immelmann is a half loop and roll, then nearer the bottom it explains the original WW1 that Immelmann did is a high energy pass, pull up some and already be using rudder to come back down, i.e. maybe a 1/4 of a loop, maybe roll a little too.

Posted
Well I know you can do Immelmann's Immelmann turn very easily in an E.III. I use it all the time.

 

Immelmann turn from 1918 aviators handbook- http://en.wikipedia.org/wiki/File:WW1Immelmann.jpg

 

-Rooster

:good:

Rooster89 & Cameljockey have the correct Immelman for WWI. So I believe it is very do able in OFF and there is less of a problem with carburetion since you don’t invert. :yes:

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use, Privacy Policy, and We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue..