decal distortion

[+Veltro2k 6,348]

What can cause this? I checked the mesh it looks fine

[+yakarov79 10,856]

DecalFacing=Bottom ?

Maybe rotate numbers on decal.

This mesh is flat?

[+Veltro2k 6,348]

mesh is a bit curved

[+yakarov79 10,856]

Had similiar look on nose of stallion. Also little curved. I just played with decal size,position.

what if :

- rotate decal and later rotate again in decals ini ?

- make bigger decal and use small scale on decals.ini

I know it might be problem with stock decal numbers but just to find solution.

[+RAVEN 414]

I had that problem before. I made the decal 32X32 then stretched it to 512 tall by 32 wide and it looks normal now. Hope this helps.

[Wrench 9,728]

hmm.. stock 3w soviet number decals are 128x/128. So,what? make them wider by a factor or 2? or 4?

that would mean 100 decals to be stretched...

 

or, I could just be inaccurate, and move it off the nose gear doors, and put it on the nose?

[+russouk2004 6,958]

I had similar prob,make sure u use x,and y co-ords for position,and facing bottom,sorted my issue,iirc,I also used a different lod number,not on pc,so cant check atm

[Wrench 9,728]

well, I can safely say the stock NA 95RT has to also, to some extent.

 

meh... maybe I'll just leave them off!!