+Veltro2k Posted October 3, 2015 Posted October 3, 2015 What can cause this? I checked the mesh it looks fine Quote
+yakarov79 Posted October 3, 2015 Posted October 3, 2015 DecalFacing=Bottom ? Maybe rotate numbers on decal. This mesh is flat? Quote
+yakarov79 Posted October 3, 2015 Posted October 3, 2015 Had similiar look on nose of stallion. Also little curved. I just played with decal size,position. what if : - rotate decal and later rotate again in decals ini ? - make bigger decal and use small scale on decals.ini I know it might be problem with stock decal numbers but just to find solution. Quote
+RAVEN Posted October 4, 2015 Posted October 4, 2015 I had that problem before. I made the decal 32X32 then stretched it to 512 tall by 32 wide and it looks normal now. Hope this helps. Quote
Wrench Posted October 4, 2015 Posted October 4, 2015 hmm.. stock 3w soviet number decals are 128x/128. So,what? make them wider by a factor or 2? or 4? that would mean 100 decals to be stretched... or, I could just be inaccurate, and move it off the nose gear doors, and put it on the nose? Quote
+russouk2004 Posted October 4, 2015 Posted October 4, 2015 I had similar prob,make sure u use x,and y co-ords for position,and facing bottom,sorted my issue,iirc,I also used a different lod number,not on pc,so cant check atm Quote
Wrench Posted October 4, 2015 Posted October 4, 2015 well, I can safely say the stock NA 95RT has to also, to some extent. meh... maybe I'll just leave them off!! Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.