Jump to content

Subcategories

    1. This pack corrects the countermeasures on the following aircraft to include the Saab BOL Advanced Countermeasure Dispenser:
       
      *F-15C http://combatace.com...ck-version-231/
       
      *EF-2000 Eurofighter http://combatace.com...urofighter-sf2/
       
      *JAS-39C Gripen http://combatace.com...for-sf2-series/
       
      *Tornado F3 http://combatace.com...ado-f3-for-sf2/
       
      *Tornado F3 (NATO Fighters 4) http://combatace.com...-update-pack-4/
       
      *F-14A & B http://combatace.com...d-f-14b-tomcat/
       
      *F-14D http://combatace.com...297-sf2e-f-14d/
       
      *RAAF F/A-18 http://combatace.com...ike-fighters-2/
       
      The BOL countermeasure dispenser is a 160 shot dispenser that has been integrated into a AIM-9/ AMRAAM launching rail (LAU-7, LAU-127/128/129,CRL,MPRL). The BOL is a non pyrotechnic dispenser that uses air scoops on the dispenser and the wing vortex of the aircraft to disperse its packets of Chaff. The countermeasure is launched rearward from a port in the rear end of the rail. For IR threats a new burning chaff product is being developed. For the above aircraft the BOL launchers are normally loaded with 160 chaff each which frees up the aircrafts existing pyrotechnic launcher/s for a full load of flares. That is what this mod recreates. The weapon station that carries the BOL launcher on the above aircraft has been made to stay even when the station is not loaded otherwise you would have chaff launching from mid air when you had no weapon loaded on that rail to make the node show up.
       
      -USAF and ANG F-15C fighters had the four wing sidewinder/AMRAAM rails replaced with BOL versions around 2000.
       
      -USN F-14A/B/D Tomcats had the BOL launchers fitted in the early 90’s in place of their two sidewinder rails.
       
      -Australian F/A-18 Hornets had BOL dispensers added to the sides of the outer wing pylons, I have been able to paint these onto the skin.
       
      -Unsure when the Tornado F3 was equipped with the BOL but they are on the two inside AIM-9 rail positions. I am unable to make the dispensing position move with the swinging wings so the chaff is launched from the position the rear of the sidewinder rails are in when the wing is in the fully swept position.
       
      -I have been able to paint on the details of the BOL launchers on the Gripen rails as the way the skin was done allowed for it. The Gripen rails still disappear when not loaded as there is no dedicated position for short range missile rails like the other aircraft and the BOL launcher is only used when an air-to-air missile is loaded on that station.
       
      http://www.saabgroup...sure_Dispenser/
       
      http://www.saabgroup...uct%20sheet.pdf
       
      Credit goes to the Authors of the original aircraft as all I have done is made a few alterations.
       
      Instillation: Simply copy and paste the included data.ini files into the correct aircraft folder and overwrite.
       
      442 0
    2. Another collection of various hangars/walls etc aimed mainly at desert type terrain although they can be used in any you like.
      600 0
    3. This is a "What If" nation missile system based off of the real SA-18 Grouse (or what I could find though internets sources).
       
      It is set for the "Taliban" nation for my Afghanistan install but can be adapted of course for any map or nation:
       
      [Nationxxx]
      Name=Taliban
      DisplayName=Taliban
      Alignment=ENEMY
      Mercenary=TRUE
      PilotNameList=NamesMercs.lst
      RankList=RanksUSAF.lst
      CallsignList=CallsignsUS.lst
      Formation.Fighter=USFighter
      Formation.Attack=USFighter
      Formation.Bomber=USBomber
      Formation.Transport=USBomber
      Formation.Tank=USTank
      Formation.MobileAD=USAD
      PilotTrainingStandard=EXCELLENT
      GenderRatio=0
      DebriefSuccessMusic=DebriefSuccess.wav
      DebriefFailMusic=DebriefFail.wav
      DebriefKilledMusic=DebriefKilled.wav
      SpeechFile=USAFSpeech.cat
      SpeechTextFile=USAFSpeechText.str
      StartDate=1994
       
      It uses Pasko's "SAM Gunner" since I have no modeling skills and is setup for SF2. It can be of course adapted for SF1 but that requires a bit of work that can be found in the SF2 Knowledge Base and is a drag and drop as all files and folders are already organized.
       
      Afghanistan rules of thumb:
       
      Kandahar-Shindand-Herat-Qala I Naw "ring" stay above 24,000ft MSL + for traveling. When you break that (usually 23,000 ft) you may get shot at. Other areas roughly 22,000 ft MSL + is a good altitude to stay above but again use flares conservatively. It's not very accurate but if enough are fired you will get shot down. I've seen earlier versions of this shred SEAD flights.
       
      This is strictly for What If scenarios or installs rather than real world setups as so far there is no heavy use of SAMs in-country.
      100 0
    4. A collection of various buildings,roads & general airfield objects designed for and tested in the SF2 Germany terrain [any version..]
      574 0
    5. This is small fix that reverts the various calibre guns muzzle flashes back to their TW default effects.
       
      Unzip to your effects folder, overwrite when asked.
       
      Sorry for my mistake
       
      Stary
      736 0
    6. Unified Effects Pack
       
      For Strike Fighters Series 2
       
      version 1.0
      26 FEB 2011
       
       
      This effects pack is a compilation of many effects I did over the years for Strike Fighters and First Eagles series of flight simulators by Thirdwire.
       
      Build around "Desert Storm FX Pack beta" released in early 2009, this pack replaces most of the stock effects with new ones, most of them volumeric or "3D" in appearance. Also used are few reworked/tuned down effects from my "Hollywood Explosions" mod, aswell as several never before relased ones.
      3,483 7
    7. Postprocess shader tweaks
       
      FOR STRIKE FIGHTERS 2 DirectX 10 ONLY!
      Made for and tested in SF2 all titles merged with Expansion Packs 1&2
      (but should work with any SF2 title)
       
      version 1.0
      30.12.2010
       
      This is set of modified Thirdwire postprocess shader variants that change the appearance of Strike Fighters 2.
       
      This mod works only in Strike Fighters 2 in Dx10 mode. Also you need to set your effects detail to unlimited for this shader to display!
      Please note that when using sepia, fake night vision and black&white shaders, various on-screen elements (like gunsight, HUD, radar display box and text) are still displayed unchanged. These are processed using different own shaders.
       
      Included are several variants, with various color corrections (old film, sepia, black and white, light green, nightvision) and various strenghts of screen vignetting.
      816 0
    8. Tracermania
      AAA Tracers and bullets modification
       
      FOR STRIKE FIGHTERS 2 Europe with Expansion pack 2
      Made for and tested in SF2 all titl mergedwithes merged with Expansion Packs 1&2
       
      by Stary
      version 1.0
      06.12.2010
       
      This little modification changes the number of tracers fired by all stock AAA units and patrol boats. Number of tracers has been increased 5 times, instead of every fifth bullet being tracer round now EVERY SINGLE bullet fired by Triple-A is tracer. Also I changed the data for stock partol boats, that makes these vessels track and attack air targets too.
      Second tweak is the increase of bullets fired in a burst by AAA crews, usually from 12 to 20 or 24. This seem to me does not make them more or less accurate.
      As these changes may increase CPU usage I eliminated ALL tracersmoke trails of any kind for any calibre guns (...)
      525 3
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use, Privacy Policy, and We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue..