View File UH-1B SAR HAF
STRIKE FIGHTERS 2
Skin for the UH-1H SAR in greek service.
Another nice skin for the Great Anatolia Terrain
You can use this skin in this Hellicopters.....
I hope you like it...
Submitter acesfakia Submitted 03/11/2013 Category UH-1
In the book "Israeli Mirage and Nesher Aces" by Shlomo Aloni, I have found the information that: Throughout its 20 years of service, the Mirage III underwent just four major technical changes in IDF/AF service – theintroduction of the ‘holding switches’, replacement of the Cyrano with ballast, swapping the Atar 9B for the 9C and, finally, removal of part of the ballast at ace Kobi Richter’s request in 1977. This moved the centre of gravity backwards, cutting minimum speed from 150 to 120
knots and increasing maximum ‘G’ from 6.5 to 7.3, thus improving sustained turn rates".
I would like to create this late modification of Mirage from 1977 for SF2 by:
1) changing empty mass of plane;
2) changing inertia of plane;
3) changing center of gravity position of plane
but I need some additional informations which I can not find:
1) have I to change any other data in DATA.ini file to properly reproduce the changes in flight model?
2) what is the mass of Cyrano Ibis radar/nose ballast?
3) how much of the ballast was removed?
4) how much has the center of gravity changed?
Thanks in advance.
So I have been working on a terrain and I noticed that for some reason Mue's Target area editor does something to the target.ini file that makes it unreadable to the TFD Tool...
This is what I did:
I used the TFD Tool to edit some tiles... All targets are labeled and show up
Then went into the Target Area Editor and made some changes to a target area and then saved...
Went back to the TFD tool and the targets were no longer readable only 5 out of 200 targets show up...
I noticed that the file TFD Tool has no problem with looks like this:
[TargetArea001] Name=target area 1 Position=414937,147250 Radius=10000 ActiveYear=0 Location=1 Alignment=FRIENDLY <--------- with the alignment= statement last and on the one saved by the Target Area Editor its 3rd [TargetArea001] Name=Target Area 1 Position=414937,147250 Alignment=FRIENDLY <-------------- here at #3 Location=1 ActiveYear=0 Radius=10000 Anyone else had this happen?
Hello Masterful SF gurus and Fans! haha! I had a question reguarding the enviromentsystem.ini file. I have Stary's awesome SARCASM 2 installed and its great for clear, broken and scattered flying but I find it to be a little too bright during overcast and inclement weather conditions... I tried myself to no avail but does anyone know the proper values to adjust in the INI to make rainy and overcast days a bit darker? Thanks a lot!